Muratec F-360 Especificaciones descargar pdf (Pagina 128)

3-103

3.8 Printer maintenance mode

In case of the following, use this mode.

• When you have replaced the Fuser unit and/or Transfer roller.

• When “Please Call Service” message appears in the LCD, access this mode to determine the cause of the

“Please Call Service” error message.

 When you replace the Fuser unit or Transfer roller, you must set the count of replacement

manually

To access the printer maintenance modes:

Note: Do not set these counters if you did not replace the Fuser unit or Transfer roller.

1. Press MENU, *, 0, 6.

The mode is contained within two main menu levels.

2. Press

or to select “Set Replace Counter” on the LCD and then press ENTER.

3. The LCD shows:

4. If you have replaced the Fuser unit, select “Replace Fuser”, then press ENTER.

Otherwise, skip to step 6.

5. Press [Enter] to reset the fuser replacement counter.

After resetting the Fuser unit replacement counter, the machine will return to the standby mode.

6. If you replaced the transfer roller, select “Replace Transfer”, then press ENTER.

The LCD shows:

7. Press [Enter] to reset the Transfer roller replacement counter.

After resetting the Fuser unit replacement counter, the machine will return to the standby mode.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 289 290

Sin comentarios

Muratec F-360 Especificaciones Pagina 128